Simons Voss Technologies Palm LDB Version 1.40 Instrukcja Instalacji Pobierz pdf (Strona 271)

LON – Network 3065

Page 9

4.0 Lock Node

4.1 Method of Operation

4.2 Assembly Instructions

The LockNodes are pre-configured by SimonsVoss and are provided with numbers

(see the picture on page N6). These numbers (GID: GroupID, M: MemberID) are

entered in the set-up diagram for the building that is to be networked. During

installation, assign the LockNodes in the software on the basis of this set-up diagram.

Do not exchange the LockNodes, since otherwise no network connection can be

made to the digital components.

The LockNodes can be built into the lighting strip next to the door in a commercially

available flush-socket device or cavity socket (at least 40 mm deep) with

accompanying dummy cap. You should completely remove the network cable

screening in the flush socket device or cavity socket (only star-shaped wiring).

In networks with no topological structure and for BUS wiring, the screening of the

respective network cables should be connected in such a way (external terminal or

soldering, each with shrink sleeve) that screening is guaranteed for the entire network

cable.

The terminator is then inserted at the last LockNode in the BUS wiring, and its

grounding cable (green-yellow) is connected to the screening (shield) or equipotential

bonding.

Wiring to the ceiling

Wiring to the floor

The LockNode takes on all programming

assignments in the network. Data is also transmitted

to the digital components by radio.

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 317 318

Brak uwag

Simons Voss Technologies Palm LDB Version 1.40 Instrukcja Instalacji Strona 271